panagiotis.k3
Posts: 7
Joined: Fri Jul 07, 2017 6:05 am
Contact: Send private message

Stringiness on prints

Tue Sep 12, 2017 6:42 am

Hi again!

My PLA and PETG prints are suffering from stringiness.

For example these PET prints. I can probably accept this is due to incorrect Slic3r settings since I was using a third-party filament.

Image
Image

But the stringiness is also present on this pre-sliced Adalinda print. This is with the PLA filament that arrived with the printer (filamentum).

Image
Image

Online videos of Adalinda printing on MK2S do no show this problem. So this points at a problem with the printer? I have no idea what to check for. Both fans are working. I am using Silent Mode. I can not be 100% certain, but I think this problem has gotten slightly worse since I deassembled and reassembled the extruder to resolve a jam. On the the other hand I used a new pre-assembled hotend, so it should be as good as new.

Thanks for any advice! Best regards, Panos

henrik.w
Posts: 115
Joined: Sun Aug 09, 2015 7:48 pm
Contact: Send private message

Re: Stringiness on prints

Tue Sep 12, 2017 7:57 am

Hello Panagiotis!

You have an excellent post here: original-prusa-i3-mk2-f23/come-to-the-d ... tml#p15304.

Hopes that can solve your problem...

/Henrik

Return to “Original Prusa i3 MK2”

Who is online

Users browsing this forum: No registered users and 14 guests