CellarDoor
Posts: 37
Joined: Jul 05, 2017 7:09 pm
Contact: Send private message

Re: Getting started with PETG (on the Mk2.5)

Dec 15, 2018 8:02 am

After quite some time, a preliminary powder coated PEI (not completely even) and sending the printer to repair I am just struggling with thislittle unevenness. It might have been the z-axis bearings as far as i understand the report.
I am even back to the completely default settings for PETG in slic3r, despite the first layer being printed a little slower.

Return to “Assembly and first prints troubleshooting”

Who is online

Users browsing this forum: No registered users and 1 guest