seth.r
Posts: 1
Joined: Mar 19, 2017 10:59 pm
Contact: Send private message

Identify print problem

Jan 23, 2019 4:32 am

20190122_232353.jpg
20190122_232353.jpg (2.84 MiB) Viewed 89 times
I just upgraded to the i3mk2.5 a the other week and prints were going fine but then all of the sudden my printer kept loosing tracking of the back right point on the mesh bed leveling.

I went in and adjusted the pinda, and now it has no problem setting that up. But never the less another problem is arising. When I run anything on the printer from a gcode I got from slic3r to the first layer calibration it seems that the extruder doesnt consistantly extrude. You can see on my brim in the picture that it cuts in and out.

Also when I run the first layer calibration it seems like there are moments where it over extruded as well.

Any help would be greatly appreciated.

User avatar
nikolai.r
Posts: 1047
Joined: Nov 09, 2016 8:32 am
Answers: 6
Location: USA - California
Contact: Send private message

Re: Identify print problem

Jan 23, 2019 4:44 am

Your first layer is too close to the bed. Adjust your live-z and it should get better, if not check your bed is even.

Return to “Assembly and first prints troubleshooting”

Who is online

Users browsing this forum: No registered users and 1 guest