User avatar
PJR
Forum moderator
Forum moderator
Posts: 5422
Joined: Jun 01, 2015 6:37 am
Answers: 26
Location: Kamnik, Slovenija
Contact: Send private message Website

Re: MK2s MMU problems

Nov 21, 2018 9:35 pm

When the filament is loaded, it is about 100mm short of the nozzle.

You have to use the correct printer profile with G-code which advances the filament into the nozzle before printing.

So what slicer are you using and which profile?

Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.

Return to “Assembly and first prints troubleshooting”

Who is online

Users browsing this forum: No registered users and 1 guest