robin.a
Posts: 115
Joined: Feb 16, 2018 10:35 pm
Contact: Send private message

Re: Difficulty with TPU

Feb 19, 2019 1:57 am

stsanford wrote:
Feb 18, 2019 3:37 pm
I get anywhere from 5-25mm up in my print and then it jams.
I get this with mine. I think its the filament. did lots of prints at 15mm/s all seemed fine every one started to ramdom fail. Got another mk3 built so ran it on that and first print was ok, but then all after failed.
Just ordered some new TPU to try again

Return to “Assembly and first prints troubleshooting”

Who is online

Users browsing this forum: Bing [Bot], McClean and 2 guests