Posts: 6
Joined: Tue Jul 11, 2017 5:31 pm
Contact: Send private message

Re: [pre-assembled i3 mk2s] print head crashes into center of bed ONLY, properly calibrated elsewhere.

Mon Sep 11, 2017 9:04 pm

aaron.s5 wrote:
Fri Sep 08, 2017 12:43 am
This is a long shot, by try re-flashing your firmware.
I did last week. it again? I mean I know "have you tried turning it off and on again" but still.

Worth a shot either way I guess. That computer's dead though, my coworker stole the power plug. I'll be able to do it tomorrow.

Also remember this printer seems to have axis-limit problems in TWO directions. The youtube video in my first post shows the Z-axis being so screwy that the horizontal steel bars bend significantly. PLUS the Y-axis knocking. I guess it's a 1D printer for the time being.

Return to “Original Prusa i3 MK2”

Who is online

Users browsing this forum: No registered users and 10 guests