Thank you very much for the update
Best regards, Peter
Well, I used the same PETG Filament from 3DPSP.de for this 150mm Bridging Test.
Thank you for using my fan duct and happy printing.christian.b6 wrote: ↑Fri Jan 12, 2018 8:08 am
In your Profile I only set Extra inflation distance to 0, Bridging extrusion multiplier to 85% and Bridging speed to 100% in S3D.
Modifications: -your fan nozzle from thingiverse, this intake https://www.thingiverse.com/thing:2718992 and a silicon sock from E3D.
The Bridging Test was surprisingly good in my opinion,
That may depend on what one considers "good results"...
Reason is that either the Prusa-profile that came with S3D and the one provided here on the 1st page both are with manual diameter. Never had any issues with layer bonding.
Users browsing this forum: Bing [Bot] and 8 guests