Search found 2534 matches

Go to advanced search

by joan.t
Sep 24, 2018 12:31 am
Forum: Assembly and first prints troubleshooting
Topic: Oops... Axis stepper and Extruder stepper transposed!
Replies: 3
Views: 38

Re: Oops... Axis stepper and Extruder stepper transposed!

Hi Ivor is the X axis motor connecter to the extruder driver on the Rambo, and installed in the extruder position, and the extruder motor installed in the X axis position and connected to the X axis driver on the Rambo there is a note in the shop, 'Ensure you are ordering the correct motor! There is...
by joan.t
Sep 23, 2018 12:19 am
Forum: Hardware, firmware and software help
Topic: Multi material use cases?
Replies: 4
Views: 53

Re: Multi material use cases?

Hi Chris,

which conductive filament do you use?

I have a roll of 'YS filament', conductive filament and it won't pull into my MMUv1, as the filament has poor strength and breaks due to the friction in the PTFE feed tube... really disappointing!

Joan
by joan.t
Sep 23, 2018 12:13 am
Forum: General discussion, announcements and releases
Topic: Day 1 Order
Replies: 6
Views: 442

Re: Day 1 Order

Hi Khalil, I'm a Big Brit Fangirl... and I got the last 2XL teeshirt! :Lol 20180923_005714[1].jpg didn't know there was a shortage! just had a look in the eshop, guess I'm not that big a girl... UK / Europe sizes are smaller than US sizes... but as you will see in the image below, both UK XXL and US...
by joan.t
Sep 22, 2018 3:50 pm
Forum: Hardware, firmware and software help
Topic: Printing replacement parts with eSun PLA Plus vs PETG
Replies: 2
Views: 73

Re: Printing replacement parts with eSun PLA Plus vs PETG

Pla should be fine for that part. No heat. Little stress... unless you crank on the belt adjuster...

Regards Joan
by joan.t
Sep 22, 2018 3:47 pm
Forum: General discussion, announcements and releases
Topic: What Happened to Live Chat?
Replies: 4
Views: 110

Re: What Happened to Live Chat?

Are you logged in to the eshop page?

Joan
by joan.t
Sep 21, 2018 11:45 am
Forum: How do I print this? (Printing help)
Topic: Which material do I have to use to print this wing??
Replies: 15
Views: 310

Re: Which material do I have to use to print this wing??

This is a model the prime factor in my experience is crash damage. Where flexibility will be a benefit
However I suspect the model would benefit from additional reinforcement around the mountings

Regards Joan
by joan.t
Sep 21, 2018 8:59 am
Forum: General discussion, announcements and releases
Topic: I have a question !!
Replies: 2
Views: 144

Re: I have a question !!

Good morning Vincity. The Hephestos is a clone of the Original Prusa i3 Idea, and it is not produced by Prusa research, to get an accurate answer you would be better asking on a forum dealing with that model of printer... However... if we assume that the BQ Hephestos is a close copy of the Original ...
by joan.t
Sep 20, 2018 8:41 am
Forum: General discussion, announcements and releases
Topic: General frustration with too many "safety" features
Replies: 2
Views: 217

Re: General frustration with too many "safety" features

How about a halfway house, fan monitoring could cause an audible alarm and then the operator could decide whether to continue or abort the print?


Joan

Go to advanced search