User avatar
Posts: 17
Joined: Sat Jun 03, 2017 11:39 pm
Contact: Send private message

Resume not Working v3.0.11?

Mon Jun 19, 2017 4:23 pm

Was trying to print the tree frog from SD. Had about the first 5% done and I noticed one of the feet was not fully stuck to heat bed. I paused the print to see if I could fix it up. Then resumed the print. It was paused for less than two minutes.

Hit resume. The heat bed warmed back up, but the hot end just continued to cool off. Waited and it cooled to ambient and kept waiting. LCD was showing waiting warming up message.

It never resumed so I had to kill the print and start fresh.

When I selected resume, shouldn't it have warmed up both the bed and the hot end and then continued with the print?

Posts: 32
Joined: Sat May 06, 2017 3:43 pm
Topics answered: 1
Contact: Send private message

Re: Resume not Working v3.0.11?

Mon Jun 19, 2017 6:53 pm

It works every time for me. I think when I pause the print, only the nozzle stops heating. Bed stays and the print temperature (It is logical, because your print could warp during the pause as the bed goes down with temperature). Try to flash the firmware once agan.

Posts: 8
Joined: Fri May 26, 2017 8:29 pm
Location: Florida, USA
Contact: Send private message

Re: Resume not Working v3.0.11?

Sun Aug 27, 2017 7:17 pm

I had the same problem today. I was running low on filament so I paused the print, unloaded the filament, loaded a new spool of filament and resumed print. The display indicated that it was trying to heat up but the extruder temperature goal was set to 0 and it cooled down all the way to room temp. Then it stayed there, "Heating....".

This appears to be a software but.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest